Bridal bouquet with jungle vibes

Wedding floristry autumn

The following flowers (botanical names) and materials were used:

  • Ophiopogon jaburan (Barendsen)
  • Pelargonium odoratus
  • Rosa Cultivar (Barendsen)
  • Velvet (Vivant)
  • Ribbon (Goldina – Da Vinci artfleur®)
  • Rubber band
  • OASIS® Lady I Bridal Bouquet holder
  • double-sided transparent adhesive tape
© Bloom´s

You can find the whole series here BLOOM’s Praxis Ausgabe 100 Juli/August 2021

This is how it is done

Step 1

Water fresh flower foam area of the bridal bouquet holder. Wrap stem with double-sided tape.

Step 2

Place snake beard parallel to the bridal bouquet holder, press firmly, fix with rubber band.

Step 3

Weave snake beard in the area of the floral foam basket around about hand width. Then insert flowers and tie ribbon partially around the stem.

Products used in this creation

OASIS® Lady I Bridal Bouquet Holder

Product features & advantages

  • Foam body with plastic grid
  • Foam basket open at the bottom
  • Ergonomically shaped plastic handle

Intended use & application tips

For wedding floristry. The plastic grid provides flowers with support. Long stems should be additionally supported and anchored to the plastic grid with wire. When cutting, make sure that the ends of the flower stems are pushed far enough into the foam for optimal water supply.

The finished bridal bouquet will last longer if it is sprayed with OASIS® Clear Life to reduce evaporation.